Disabling Camera Mode - IDentiFake

Disabling Camera Mode on IDentiFake

The following guide below explains how to disable camera mode for IDentiFakes.

Step 1) Go to Settings.

Step 2) Go to Configuration. 

Step 3) Go to Advanced Settings.

Step 4) Go to the IDentiFake tab and uncheck Camera Mode. Click Save when done. 

Step 5) Head back to the Main Screen to scan IDs again.

• Related Articles

• IDentiFake M-150 or M500 scanner is not scanning or accepting any IDs.

  Problem: The IDentiFake M-150 or M500 scanner is not scanning or accepting any IDs. Not Accepting IDs: The motors will not automatically pull the card into the reader. Not Scanning IDs: The scanners pull in the ID as normal but do not show the ...

• IDentiFake Training Tutorial - Scan Results

  IDentiFake Tutorial How to Interpret Scan Results Introduction The purpose of this document is to detail how the IDentiFake system works, and most importantly, how to interpret/respond to the scan results. Introduction Welcome to Your ID Security ...

• How to Use DMVCheck on IDentiFake

  This article will provide a tutorial on how to use DMVCheck on IDentiFake and assumes that you already have an existing DMVCheck subscription. For a guide on setting up a subscription, please see this article. DMVCheck Overview DMVCheck service ...

• Post Windows 11 Update Checklist for Surface Tablets Optimizing Settings for Windows 11 and IDentiFake

  Post-Windows 11 Update Checklist for Surface Tablets: Optimizing Settings for Windows 11 and IDentiFake After updating your Surface tablet from Windows 10 to Windows 11, please double-check the following settings, as Windows may reset some ...

• Disabling Barcode Detective on an IDVisor Smart V1/V2/Plus/S50

  Disabling Barcode Detective Enhanced ID Detection Service From Barcode Detective (formerly known as IDSentry) TokenWorks ID Scanners now feature Barcode Detective. Barcode Detective is a new subscription service that will help detect fake IDS. ...