M260 DL Parsing Scanner Diagnostic

M260 DL Parsing Scanner Diagnostic


M260 DL Parsing Scanner Diagnostic

The M260 Diagnostic application is a tool you can use to diagnose, troubleshoot and correct problems with the M250, M260, M280 scanners, a.k.a. eseek scanner, that is used in the IDWedge or IDWedgePro applications or DL Parsing Scanner SDK.

This is Version 4.1 of the M260Diagnostic application, for use on Win10

When running this app, be sure no other apps are connected to your scanner.  You should have the scanner plugged into the PC before your run this app, and you need to restart the app each time you run it.

The app will try to find the scanner by interrogating the PC, if it can’t find the scanner (and it is plugged in) this indicates the driver is missing, and will display a link to installing the VCP driver from FTDI

The app can verify the registration code, and also verify if the scanner was programmed for our Parsing DLL (where the license is in the scanner) or TokenWorks Desktop apps like: IDWedgePro Form Filler, IDVisorSentry Access/AgeVerification and our NodeLocked Parser, all of which require an activation code to run.

The app has two buttons to allow changing the configuration between the two configurations, and these will be available only if the scanner has be found to be properly registered/sold by TokenWorks

Download and unzip to your PC:

TokenWorks Scanner Test_4.1.zip



    • Related Articles

    • IDentiFake - Dirty Scanner Alert

      Dirty Scanner Alert on IDentiFake If you’re receiving a “Dirty Scanner Alert” error message, it means the scanned image quality is low. This is normally caused by dirt build up from IDs. To accurately authenticate IDs the scanner must produce a ...

    • How to Add a Scanner to a Sync Account

      How to Add a Scanner to a Sync Account The instructions below provides step by step details on how to add a scanner or change a scanner name on your Sync account. This can be done using the Sync Console or the Sync Web Portal. If you purchased ...

    • How to connect a scanner to IDVisor Sync

      How to Connect a Scanner to IDVisor Sync When adding a scanner or changing a scanner name on your Sync account, the changes will have to be added to your physical scanner as well to continue uploading data. See here on how to add a Scanner to your ...

    • Scanner Beeps but does not Display Data

      Scanner Beeps but does not Display Data/Not Connected Error Problem: When scanning a 2D barcode, the scanner beeps, but the data is not being displayed. Possible Cause: This could be caused by the scanner not connecting when the application starts ...

    • IDentiFake M-150 or M500 scanner is not scanning or accepting any IDs.

      Problem: The IDentiFake M-150 or M500 scanner is not scanning or accepting any IDs. Not Accepting IDs: The motors will not automatically pull the card into the reader. Not Scanning IDs: The scanners pull in the ID as normal but do not show the ...