Upgrading from IDWedge to IDWedge Pro

Upgrading from IDWedge to IDWedge Pro


Upgrading from IDWedge to IDWedge Pro

An IDWedge can be easily upgraded to an IDWedge Pro by following these steps:

  1. Contact Tokenworks (800-574-5034 ext 1) and purchase the IDWedge Pro software upgrade for $100
  2. Download Software – IDWedge Pro 1.0.1.1
  3. Install Software – Installation Guide
  4. Activate Software – Using the activation key provided by Tokenworks
  5. Use IDWedge Pro

Once the upgrade is complete – the IDWedge will be compatible with both the IDWedge and IDWedge Pro software. Users will be able to easily switch between programs.



    • Related Articles

    • Latest IDWedge Pro Software Updates

      Latest IDWedge Pro Software Updates Release Date Software Version Description How to Download 3/6/26 2.4.7.0 Version 2.4.7.0 improves license validation for offline users, controls the M280 message box: “No face detected” with the suppress user ...

    • How to make IDWedge Pro run on Windows Startup

      How to make IDWedge Pro run on Windows Startup How to Run IDWedge Pro at Windows Start Follow the directions below in order to have your IDWedge Pro software run when Windows boots up. Note: IDWedge Pro must be enabled to Run As Administrator for the ...

    • IDWedge Pro Backing Up and Restoring Formulas

      IDWedge Pro: Backing Up and Restoring Formulas How to Backup/Restore Formulas for IDWedgePro This post will guide you on how to backup/restore the formulas you created in the IDWedge Pro program. It also guides M280 users on how to back up their ...

    • IDWedge Pro crashes when launching Formulas

      IDWedge Pro crashes when launching Formulas Issue: The IDWedge Pro application will try to open up Formulas but immediately crash after an attempt. No immediate error messages are shown, but if you open Event Viewer to see why the application ...

    • Imager Drivers for IDWedge Pro – m280

      Imager Drivers for IDWedge Pro – m280 Post Description: How to install M280 image drivers if IDWedge Pro is scanning 2D barcodes properly but does not recognize the image capture from the m280 (i.e., says USB Info Disconnected). This driver is ...